Skip to content

Getting started with Solstability

From the shape of the ground to a verified slope.

  1. Shape the ground

    Soil Layers → Templates… builds a single or benched slope, an embankment, an excavation or a layered slope from a few dimensions. Edit every point afterwards in Soil Layers and Interfaces, or import the ground from DXF or LandXML.

  2. Soils and water

    Add the soils in Soil Parameters (effective or total stress) and give each layer and polygon its soil in Assign. In Water choose a ground water table, ru, rapid drawdown, suction or pore pressure isolines; Templates… places a typical table.

  3. Loads and reinforcement

    Place strip, trapezoidal, line and point loads in Loads, and switch on the pseudo-static earthquake there. Anchors, soil nails, geotextiles and stabilizing piles go in Reinforcement, drawn on the slope or typed in.

  4. Choose the analysis

    In Analysis select a circular or polygonal slip surface, the method and the design situation, and the type: a standard analysis of your surface, an optimization, a grid search or a random search.

  5. Run and review

    Run Analysis (F9). The factor of safety, the moments and forces appear on the drawing — green when the requirement is met, red when not. The Results step lists the slices, the stresses on the slip surface and the forces of the reinforcement.

  6. Prepare the report

    Open Report… in the Results step, choose the sections and add views of the drawing, then export to PDF, Word, Excel or HTML.

When something needs attention

The circle does not cut the ground surface

The slip surface must enter and leave the ground at the surface. Draw the circle with Draw circle through two points of the ground, or enlarge the radius; a polygon must start and end on the ground.

The method did not converge

Often a steep slice base at the crest or toe, a missing tension crack above a cohesive slope, or large point forces. Check the slip surface, add a tension crack, or compare with another method; the value shown should not be used.

The critical surface sits at the edge of the model or of the search

The true critical surface may lie beyond it. Extend the model, move the grid or widen the ranges of the random search and run again.