Start from a template
File → New Model opens the layout templates: rectangular, staggered, triangular, circular, radial batter, trestle or a line of piles. Set the number of piles, the spacing, the pile length and the units, then confirm. The piles and the cap are drawn for you; edit or add piles anywhere with the Draw tools.
Define the sections
In Define → Section Properties → Pile Sections choose an elastic section or a nonlinear concrete, steel or prestressed section, and set the cap thickness and material under Cap Sections.
Build the soil profile
Add the soil layers with their p-y models in Define → Soil → Soil Layers, then stack them in Define → Soil → Soil Profile with the water table and scour. Use Sloping… for a sloping ground surface.
Apply the loads
Create load patterns and load cases, put the forces and moments on the cap with Assign → Cap Loads, and combine the cases in Define → Load Combinations.
Check and run
Analyze → Check Model (F6) lists anything that would stop the run; a click on a message selects the objects concerned. Then Analyze → Run Analysis (F5).
Review and report
Display the deformed shape and force diagrams on the model, the forces along each pile and the cap response, and every value in Display → Show Tables. Export a report to Word, PDF or Excel with File → Export → Report Builder.
When something needs attention
Check Model lists an error
Click the message to select the piles or objects it names. Typical errors: a pile without a section, a pile that does not reach the soil, or a load on an object that no longer exists.
A pile is drawn outside the cap
Every pile head is tied to the cap; a rigid cap ignores its outline and Check Model warns. With a flexible cap, regenerate the mesh after moving piles. A pile that stands on its own is analysed in a single-pile model.
A load case does not converge
The load may exceed what the group can carry. Read the message of the run, reduce the load or apply it in steps, and check the soil parameters and the group factors.